Want to relieve razor burns?

One of the best forms of prevention is allowing hairs to grow well above the skin surface. The follicle opening may prevent the hair tip from growing into the skin. However, not many people are willing or able to grow their hairs long enough to prevent their ingrowing. The following are essential key points that will help minimize these shaving problems: Washing the skin before shaving is helpful in exfoliating. Exfoliating (removing the upper layers of dead skin) your skin is indispensable when trying to prevent razor bumps, ingrown hairs or razor burn.

Daily use of a liquid cleanser before shaving not only unclogs pores, it lifts the hair away from the follicle while softening the hair. Shave with downward strokes (going with the grain). Shaving too close is one of the triggers for razor bumps, ingrown hair, and razor burn. The hair stubs are cut too close, get trapped inside the hair follicle and dig inward or sideways. Use a post-shaving product that contains beta hydroxy acid: Acetylsalicylic acid, the main ingredient in the Imperial Touch Razor Bump Solution. This dermatological-grade ingredient is the active substance producing immediate; visible improvements for razor bumps, ingrown hairs, and razor burns. It disinfects, mildly exfoliates surface skin cells, which keeps hair follicles and adjacent areas of the skin clean and unobstructed.

Many people experience razor burn or other forms of shaving discomfort simply because they don't take the time to properly soften the hairs before shaving.You need two or three minutes of soaking the hairs before you actually start shaving. Wet hair in the area to be shaved with a hot towel for 15 seconds before shaving or at the end of a shower. With the use of a good razor blade, hair that is wet through and through cuts smoothly and effortlessly. Hair that is not completely wet, however, can be as strong as reinforced concrete. Cutting through such tough hair often causes hairs to be pulled up from their follicles as they are being cut. These hairs then retract below the flush surface to skin where they are at risk for curving back into the skin as they grow rather than out through the follicle.

The forces required to cut such hair also can translate into more friction on the skin that can promote razor bump, ingrown hair, or razor burn. The key is to not dry your skin. While your skin is still wet, apply a shaving gel, Imperial Touch Aloe Vera Shaving Gel.Wait a minute or two and then shave. Shave with the skin in a neutral relaxed position. This is the best way to shave hair close but not too close. Sometimes the skin must be stretched very slightly to allow the razor to pass smoothly without nicking. Excessive tightening of the skin when shaving, however, tends to result in hairs being shaved below the resting surface of the skin. This occurs because as the skin is stretched tight the hairs actually protrude out a bit farther than when the skin is relaxed.

Shaving over stretched skin may cut the hairs below the flush surface of resting skin, increasing the risk of ingrown hairs and also increasing the risk of skin irritation. Shaving gels are important in the treatment of razor bumps, ingrown hairs and razor burns. A good shaving gel will minimize the friction associated with shaving and reduce the likelihood of ingrown hairs and skin irritations. In addition, avoid using double or triple-edge razors when possible. Satisfaction is always guaranteed.

Sign Up For Exclusive Offers From VarNasol.